...Source impedance. 2100 mV input step.
50 mV OD
IV V IV 2
3
ns ns
0.5 1.2 1.2
ns ns ns
20% to 80% 20% to 80%
V V
T...up and hold times are a measure of the time required for an input signal to propagate through the fi...
...ge Control Loop Active ALC Gain Step Control loop gain step ALC Dynamic Range Voltage control loop reference threshold on Vsense pin Hystere...up to 400mApeak), is set by means of an external resistor (RCL) connected between CL and PAVss. The ...
...t, then the motor will move one step only and will oscillate in its new position. The amplitude of the oscillation must decrease sufficientl...up to 2.2 V only if the selected motor EMF remains in the wrong polarity (watchdog function). At the...
...kHz Settling Time ( 10 mV, 20 V Step) * G = 1 V/V 150 s G = 100 V/V 500 s Slew Rate (G = 1 V/V) 1 V/s OFFSET VOLTAGE (RTI)2 Initial, @ +25C ...up to 10 V is shown in Figure 2. Additional input amplifier variations are shown in the following f...
... is designed to control a DC/DC step-up (boost) converter using an N-channel power MOS FET. The output logic of the HA16114 is designed to control a DC/DC step-down (buck) converter or inverting converter using a P-channel power MOS FET. Th...
Description
Switching Regulator for Chopper Type DC/DC Converter
...ut logic is preset for booster, step-down, or inverting control in a DC/DC converter. This logic assumes use of an N-channel power MOS FET f...Up r r -- r -- -- -- r Step-Down r r r -- r r r -- inverting r r r -- r -- r -- Totem pole power MOS...
Description
Switching Regulator for Chopper Type DC/DC Converter